The cause is usually one of five things. Working through them in order saves time, and it stops you paying for a part you did not need.
1. Start with the filter and the indoor coil
A blocked filter starves the unit of air. The coil gets cold, airflow drops and the room never cools, even though the compressor is working hard. In a coastal flat with windows open, dust and salt film build up faster than most people expect.
Wash or replace the filter, then look at the indoor coil through the grille. If it is matted with dust or lint, it needs cleaning properly, not just a brush over the surface.
2. Check the outdoor unit is actually running
If the indoor fan runs but the outdoor unit is silent, the system is not transferring heat. Listen for the compressor and the outdoor fan, and check whether the unit is getting power at the isolator.
A condenser coil packed with dust, salt and lint will also push pressures up until the system protects itself and stops cooling. Coastal units need the coil cleaned far more often than inland ones.
3. Look for signs of low refrigerant
Ice on the indoor coil or on the small copper pipe, poor cooling that gets worse over weeks, or a hissing sound at the flare connections all point to a leak. Refrigerant does not get used up: if it is low, it escaped somewhere.
Topping up a leaking system is a temporary fix. The leak has to be found and repaired, then the circuit pressure tested and charged correctly.
4. Rule out the obvious settings
Fan-only mode, a set point that is too high, a timer or sleep setting, or a remote that has switched the unit into dry mode will all look like a fault. Check the mode and set point on the indoor display, not just the remote.
5. Accept when the unit is simply too small
A unit that was sized for a smaller room, or installed before glazing and occupancy changed, will run continuously on a hot day and still lose ground. No repair fixes undersized equipment. If the system is correct but cannot keep up, the answer is usually a capacity or airflow change, not another part.
Questions about this
Why does my aircon blow cold for a while and then stop cooling?
That pattern often points to the indoor coil freezing over. Ice blocks airflow, cooling stops, then the ice melts and it works again briefly. Low refrigerant, restricted airflow or a faulty sensor can all cause it.
Can I just add gas?
Adding refrigerant to a leaking system only postpones the failure. The leak should be located, repaired, pressure tested and then the correct charge weighed in.
How often should filters be cleaned near the sea?
In Sea Point, monthly checking during summer is realistic for a unit in daily use. Clean it when it is visibly dusty rather than waiting for a set date.