Salt does not just look bad. It is hygroscopic, it holds moisture against metal, and it accelerates the corrosion of aluminium and steel. On refrigeration and air-conditioning equipment, that shows up as reduced performance long before anything visibly fails.
What fails first
A corroded coil cannot transfer heat properly. The unit runs longer, uses more electricity and eventually cannot hold temperature at all.
- Aluminium condenser and evaporator fins, which corrode and then crumble
- Fan blades and motor bearings, which stiffen and become noisy
- Steel brackets, screws and casing seams, which rust through
- Electrical terminals and contactors, which corrode and cause intermittent faults
- Copper pipework at flare joints, where salt and moisture collect
The routine that actually helps
Regular cleaning is the single most effective measure. Rinsing salt and dust off the coil and casing, with the power isolated, removes the electrolyte that drives corrosion. Cleaning frequency should follow exposure: a unit facing the sea on a balcony needs far more attention than one sheltered inland.
- Clean condenser coils on a schedule, not only when performance drops
- Keep brackets, fixings and casing seams painted or coated
- Check and protect electrical terminals during every service
- Keep drain paths clear so water does not sit against the casing
- Position new outdoor units away from direct salt spray where the building allows
Protective coatings: useful, not magic
Factory-applied coil coatings and aftermarket treatments slow corrosion, but they do not make a unit salt-proof. A coated coil still needs cleaning, and a damaged coating can trap moisture if it is not maintained.
Where a unit is being replaced in an exposed position, choosing equipment with better corrosion protection is worth considering. It is a cost decision, and we will give you the trade-offs rather than a guarantee.
What to look for between services
White powder on coil fins, rust streaks on casing, a fan that sounds louder than last summer, or a unit that runs longer than it used to are all early signals. Catching them at that stage is usually a clean and a small part, not a replacement.
Questions about this
How often should coastal units be cleaned?
For an exposed Sea Point unit, cleaning every few months during the windy and humid seasons is realistic. A sheltered unit can go longer. We set the interval after seeing the position.
Can corroded coils be repaired?
Light surface corrosion can be cleaned and protected. Once fins are crumbling or the coil is leaking, replacement is usually the practical option.
Does a coil coating mean I can skip cleaning?
No. Coatings slow corrosion but still need cleaning, and salt and dust sitting on a coated coil will still reduce performance.