Sea Point service

Cold room installation and repairs

A cold room is only as good as its weakest part. A perfect refrigeration unit cannot compensate for a warped door, a torn seal, a blocked drain or a panel joint that lets moist air in. That is why cold room work starts with the room as a whole, not just the box outside.

A cold room is only as good as its weakest part. A perfect refrigeration unit cannot compensate for a warped door, a torn seal, a blocked drain or a panel joint that lets moist air in. That is why cold room work starts with the room as a whole, not just the box outside.

Reyds installs and repairs cold rooms and walk-in fridges in Sea Point for restaurants, delis, butcheries, bottle stores, pharmacies and guesthouses.

New cold rooms

We size the room around what will be stored, how often the door opens and what temperature range is needed. Panels, door type, evaporator position, shelving and the condensing unit are chosen together, with hygienic finishes where food is handled.

  • Chiller rooms, freezer rooms and dual-temperature rooms
  • Insulated panels, hinged and sliding doors
  • Evaporators, condensing units and controllers
  • Temperature and defrost settings set for the actual use
  • Drainage and door heating for freezer rooms

Repairs and fault finding

When a cold room stops holding temperature, the cause can sit anywhere between the controller and the door seal. We test the refrigeration circuit, defrost operation, airflow, drainage and the room's seals and panels.

  • Room not reaching or holding temperature
  • Ice build-up on the evaporator, ceiling or floor
  • Door seals, hinges and closers that no longer seal
  • Defrost failures and blocked drains
  • Refrigerant leaks and faulty components
  • Controller and sensor faults, including alarm conditions

Siting plant on the coast

External condensing units in Sea Point take salt spray and wind-driven rain. They need clearance for airflow, secure mounting, protected electrical connections and a cleaning routine. Where possible we site plant away from the prevailing salt wind and out of direct spray.

Keeping a cold room reliable

Most cold room failures we see started as a small thing: a torn seal, a drain that stopped flowing, a defrost cycle that ran too long. A planned maintenance visit checks those before they cost you stock.

Cold room installation and repairs questions

How long does a cold room installation take?

A small chiller room can be built in a few days, while larger or freezer rooms take longer, especially where building work and electrical supply are involved. We confirm the programme after a site visit.

Can you repair a cold room you did not install?

Yes. We survey the room, panels, door and plant first so you know what condition it is in before we quote repairs.

What temperature should my cold room run at?

It depends on the product. Chiller rooms generally run between about 1°C and 5°C and freezer rooms well below freezing. We set and verify the temperature against what you actually store.

Why does ice build up on the floor of my cold room?

Usually a blocked drain, a failed defrost cycle or a door seal letting humid air in. Floor ice is a slip risk and it also damages panels, so it is worth fixing promptly.

Reyds · Sea Point

Need cold room installation and repairs in Sea Point?

Send us the equipment details and what it is doing. We will confirm the next step and a time to attend.

Call now WhatsApp